Anyone in Orange County, Ca. have LS1-Edit and want to help a brutha out. Just put in a Trans-Goshift kit and its bogging after a hard shift due to torque management. I'd hate to pay big bucks for the edit software for such a little thing, but I MUST disable it...I even have the four step procedure written down!

Hook me up, I'll buy you lunch and get you loaded heh heh...

 

LS1-Edit is locked to the PCM unless you have the tuner version. Hopefully a tuner in that area can do it for you cheap...

btw, are these the steps you're referring to?
---snip---
Go to transmission -> A4 Shift Firmness -> Torque reduction and zero out the table
Trans Cal -> A4 Shift Firmness -> Upshift Torque reduction - zero out the values
Engine -> Ignition -> Max Torque. Set it to 1000
Engine -> Ignition -> Torque Reduction. Zero it out
---snip---

 

your SOL bud..

 

Yes, those are the settings...What do you mean **** out of luck Phantom?? Sounds like I just have to get someone with a tuner version to tweak a couple settings.

Not too difficult....Heh heh.

Thanks Jim M.

Blow me Phantom TA.

 

You're kidding, right?
Telling a mod to blow you........
Too much *****, not enough brains.

 

You were asking if someone on the board good do it for free. And that answer was no.. Your goin to have to pay just like everyone else...

For a network engineer you sure do seem like a 12 year old kid. Where do you get off saying that to me, or anyone else on this board?

 

Please be more respectful from now on. That kind of attitude is not tolerated here, especailly toward a moderator of the site.