Check out this 228?
#1
Check out this 228?
This looks kind of interesting. What do you guys think of this cam?
Would it make good power for street/strip? I dont want to rev past 6500.
It uses the z-cam lobe profiles.
http://www.sdpc2000.com/catalog/3876...0-0600-113.htm
Its advertised duration is 290 @ .004....so I dont know how to compare the ramp rate. I know using duration @50 compared to gross at .006 can get you ramp rate. But in this case the ramp would be 62...and I know thats not right.
So how can I convert 290 @ .004 to what it would be at .006?
If the ramp ends up being between an xe and xe-r I am getting this cam
How do these base circles compare to the other cams?
Is .600 lift too much for a 228?
I am just looking for something a little different than everyone else.
thanks a lot, Troy
__________________
Would it make good power for street/strip? I dont want to rev past 6500.
It uses the z-cam lobe profiles.
http://www.sdpc2000.com/catalog/3876...0-0600-113.htm
Its advertised duration is 290 @ .004....so I dont know how to compare the ramp rate. I know using duration @50 compared to gross at .006 can get you ramp rate. But in this case the ramp would be 62...and I know thats not right.
So how can I convert 290 @ .004 to what it would be at .006?
If the ramp ends up being between an xe and xe-r I am getting this cam
How do these base circles compare to the other cams?
Is .600 lift too much for a 228?
I am just looking for something a little different than everyone else.
thanks a lot, Troy
__________________
Last edited by UltraZLS1; 03-17-2006 at 08:17 PM.
Thread
Thread Starter
Forum
Replies
Last Post
teal98
Automotive News / Industry / Future Vehicle Discussion
15
09-16-2002 01:23 PM
danielbmx
Car Audio and Electronics
0
08-27-2002 11:11 PM
johnsocal
Automotive News / Industry / Future Vehicle Discussion
21
08-17-2002 01:06 AM
SilverWS6
Automotive News / Industry / Future Vehicle Discussion
13
08-14-2002 09:29 PM
newby
Automotive News / Industry / Future Vehicle Discussion
10
07-27-2002 11:39 AM