Just wondering how hard it is to take off/put back on the front bumper cover on a 4th gen Camaro. Looking at it dosent seem to bad, but would like an idea before i start it.
Thanks, Mike

 

Takes 10 minutes. Two bolts on far left side at fender. Two on far right at fender. Two in center at lightbar, then pop all out the rivets. There's three on the bottom, and i think 8 or so up top. Pull out the center piece, and the whole plastic rivet will come out in one piece, ready to reuse.

 

easy - i did 4 this summer rebuilding mine - im at work right now but shoebox's write up site has a nice diagram of the front bumper exploded -

 

Its not all that bad. Unless you've never worked on a fourth gen. at all. I took mine off on the side of a street 250 miles away from home and had no idea where the bolts/fastners were. Of course it was about 10 degrees, I was laying in ice and snow, and I couldn't feel my fingers. It took me a few hours, but that's what I get buying a non-driving camaro, and dragging it home from Minnesota between snow storms. Oh yeah, it took me 15 minutes to put back on. So yeah, I agree with the rest of the posts, this time of year it should take 20 minutes tops.