I picked up a small power washer fom Wal-Mart today for 80 bux, works good. 1400psi.

My motor is out right now and its just the wiring and tranny there.

I cleaned my engine bay, with a crap load of degreaser and the power washer, came out very nice, lol i never new the steering rack was silver haha

K

MY question is?

I got some water on the connections, like the harness, is that ok? It wasent a DIRECT blast at it but it got some water on it??

 

I would be more worried about the opti than the wiring harness...

 

Good lord......I don't know why anyone would ever take a powerwasher to an LT1 engine.

 

engine was is a no-no....it ruined my opti and plugs...

 

theres no motor

 

did anyone read it

lol of course i didnt wash an engine especially a LT1

 

Yea I can read

Well then if your worried about the wires you can spray them with some contact cleaner and try to clean all the debris that you may have washed onto them.

 

ohh yea i've always seen that stuff...never used it

thanks ill give that a shot

 

Try some Water Displacement formula #40, (WD40)... It seems like that's what it's made for...

 

My exact adivce, use WD40....

 

Hmmmmm....
If you can't spray inside the engine compartment...how do you keep it clean in there??...
Or do you just let it go......
Drive On
Fred

 

Good old fashion elbow grease!!! But I have power washed a little bit of the engine, but BE VERY CAREFUL AROUND THE OPTI AND COMPUTER