General 1967-2002 F-Body Tech For general F-Body discussion that does not fit in any other forum.
For F-Body Technical/Information Discussion ONLY

How did you do the wiring for your cutout?

Thread Tools
 
Search this Thread
 
Old Sep 9, 2006 | 08:38 PM
  #1  
micfly83's Avatar
Thread Starter
Registered User
 
Joined: Dec 2005
Posts: 343
From: Orlando, FL
How did you do the wiring for your cutout?

Just wonderin how everyone did the wiring and where they mounted the switch for their electric cut out.

Thanks
Old Sep 10, 2006 | 01:36 AM
  #2  
LT1 POWR's Avatar
Registered User
 
Joined: Apr 2005
Posts: 1,830
From: Colorado Springs, CO
Re: How did you do the wiring for your cutout?

I went up through the plug underneith the rear passenger side bucket seat, its right by where i mounted my cutout. Went under/along side the seat, up into the center console and i have the switch in my ashtray. The wire only shows about 1-2" his way, but isnt realy noticeable. Ive got my manual fan switch and my electric cutout in my ashtray.
Old Sep 10, 2006 | 01:18 PM
  #3  
94_PatriotRed_Z's Avatar
Registered User
 
Joined: Jul 2005
Posts: 697
From: Greenville, NC/ Daytona Beach, FL
Re: How did you do the wiring for your cutout?

Originally Posted by LT1 POWR
I went up through the plug underneith the rear passenger side bucket seat, its right by where i mounted my cutout. Went under/along side the seat, up into the center console and i have the switch in my ashtray. The wire only shows about 1-2" his way, but isnt realy noticeable. Ive got my manual fan switch and my electric cutout in my ashtray.
Yup me too... but none of my wire shows because ran the wire under the carpet to then center council then I pulled the whole center council out and ran the wire there, my switch is mounted right next to my cig. lighter

Do a search on here there was a good write up of how to do it with pics done sometime around March or April

Last edited by 94_PatriotRed_Z; Sep 10, 2006 at 01:21 PM.
Old Sep 11, 2006 | 12:04 AM
  #4  
mmmchickenboy's Avatar
Registered User
 
Joined: Sep 2004
Posts: 267
From: South Bend or Ft. Wayne, IN
Re: How did you do the wiring for your cutout?

my cutout was just behind the cat and i ran the wire forward into the front subframe and up through the rubber drain plug under the carpet (in front of the pass seat) then snaked the wire through the dash, the excess wire coiled up nicely on top of the trim/kick panel that sits under the glovebox.

picture of switch location:

Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
BLK1997Z28
LT1 Based Engine Tech
13
May 7, 2015 03:01 PM
birdblack
Exhaust System
0
Jan 4, 2015 09:41 PM
lbrowne
LT1 Based Engine Tech
25
Nov 13, 2011 04:25 PM




All times are GMT -5. The time now is 10:03 AM.