So I can't seem to find the oil feed fitting for my supercharger, guessing it was lost when I moved a few years ago (or put in the most secure place I've forgotten about). Anyhow, does anyone know where I can find a fitting that isn't incredibly overpriced? $55 seems a bit much for one fitting.

This is what I'm after.

 

I think it's a custom made, low volume part. $55 seems like a lot, but then they sell everything for a lot. I'm sure you could build one if you had a good look at the hole size, etc, but that would take you all day assuming you had the ability and machines to do it.

 

i had to buy one because my used kit didn't have. I thought about making one, but after finally dishing out the cash i'm glad i didn't. I was worried about making the hole too big and possibly affecting oil pressure on the motor. And the feed hole is very small.