Another FI opti vent thread
Registered User
Joined: Oct 2008
Posts: 37
From: Jackson, MI
still gapped at .040, pops at WOT (issues tend to arise when boost kicks in --so around 3000rpm or under load)
I fooled around with gapping (.028-.045) probley 4 mths ago
I fooled around with gapping (.028-.045) probley 4 mths ago
Last edited by leachbuz; Sep 5, 2010 at 05:37 PM.
Thread Starter
Registered User
Joined: Sep 2004
Posts: 1,152
From: Wyoming
Check all connections! Turns out after I put on my new opti...still no start. Drove to cheyenne to pick up a coil...still no start. Decided to unhook the msd box and found the green wire to the coil was loose.
Also I picked up a filter from autozone...basically a small breather(3/8") and ran 3/8'' hose from the opti cap to the filter. Hooked up the vacuum with the orifice and and check valve like normal. Just got done driving for 25 miles or so and its running great! It idles much smoother and doesn't stumble if you gun it under 3k rpm. It always did before and I think the coil was on its way out.
Also I picked up a filter from autozone...basically a small breather(3/8") and ran 3/8'' hose from the opti cap to the filter. Hooked up the vacuum with the orifice and and check valve like normal. Just got done driving for 25 miles or so and its running great! It idles much smoother and doesn't stumble if you gun it under 3k rpm. It always did before and I think the coil was on its way out.
Registered User
Joined: Dec 2000
Posts: 1,320
From: Alta Loma, CA
Re: Another FI opti vent thread
Do you have any pics of this installed? I like how this sounds.
My setup has that big rubber 'Cobra' head on the inlet of the Turbo. I punched a small hole into that and THAT is my source of vacuum. The air filter tube comes off the other side of the Cobra and has the filter on it. It always has vacuum on it when the motor is running and never is pressurized.
Thread
Thread Starter
Forum
Replies
Last Post
SpraydZ
Parts For Sale
42
Jun 7, 2016 01:44 PM
