not happy with magnaflow
i have a similar setup...stock manifolds, Stainless works o/r y-pipe,,,dynomax bullet res. instead of cat,, and a magnaflow muffler , with the 2otl outlet and single inlet,,,,,
just throw a bullet and it will sound fine,,,alot less popping and cracking with the bullet
just throw a bullet and it will sound fine,,,alot less popping and cracking with the bullet
so what exactly would it sound like without the bullet,,,so i would run just the offroad y-pipe and the magnaflow muffler
im tempted to take the bullet off
I did this and the bullet muffler failed in 6 months from the extreme heat just post manifolds, or in my case headers. The insides started deforming, then it fell apart.
Running no cats makes some rasp. Its not the magnaflow. Even my Borla had some without cats.
I destroyed my cats running a D1 on 383ci LT1. Removed them and ran 2 1/2 straight thru pipe. Lots of bad resonance @ 2k to 2.5k rpm on a Spintech 3 1/2 muffler. Could not live with it. I did a 3 1/2" cc 3-disc insert in the pipe before the axle. No more resonance and did lower the noise. I still open 3 1/2" qtp when I need to for max flow.
Definatly dont go Borla if you dont want rasp. I just did LT's, no cats, on Borla and it is LOUD and raspy at 2000-2500 rpm range. Im looking to add a bullit muffler of just change to something else.
If you're complaining about raasp w/ no cats on a Magnaflow, you'll hate the Borla.. I had one for years.. LT's ORY w/ no plate and it was all rasp..



