As the title says. I'd like to seriously know who has NOT had problems w/ their Spec clutch/PP or different FW setup.... (Reserarch for others aswell as myself.)

What did you do that maybe different than other PPL? (refering to install) PN's? Hydraulics? What failed and/or what was fine. Is there a problem w/ common years/applications? What could be done to prevent future problems?

 

Almost 20,000 on mine. I'm using the stock flywheel and stock master cylinder.

 

Same here installed a stage 3 on a stock flywheel that was milled down, stock hydraulics, still running strong almost 35k miles later.

 

Mine died after 8K miles. It was a stage III with their billet steel 'wheel.

Ben T.

 

This is a NON-problem related thread. Thanks anyway.

 

Had a buddy kill a stage two (just completely wore the lining off) then I stuck a stage III in it with stock resurfaced PP and stock hydraulics and he loves it.

 

My Stage II is perfectly good. I just pulled it out because of some phantom grinding noise in that area. I have just under 3k on it and it looks great.

 

had mine for 10,000 miles and two years and no problem, stg 2, stock flywheel

 

THe negitive responses are fine. but this isn't srictly a complaint thread.

Mabie there is a problem w/ their flywheels. You would figure a company that invests money to produce these would have them work correctly.