T56 Rebuild
Thread Starter
Registered User
Joined: Jul 2006
Posts: 8
From: Northeast Atlanta
T56 Rebuild
Need some suggestions. I recently bolted up D1SC to the Stroker and find myself with 525rwhp and a 4,300lbs car 
The Spec Stage 3 and pilot bearings held up, but the last inch of the input shaft did not...SNAP! I suspect the used 96 Z28 T56 I had rebuilt 2 years ago could not take the torque.
So I'm in the search of T56 specialists that can make sure this doesn't happen again. I live in Atlanta area. I did find T56rebuilds.com in TX but was hoping there was someone local. The trany is already out.
Thanks in advance.
The Spec Stage 3 and pilot bearings held up, but the last inch of the input shaft did not...SNAP! I suspect the used 96 Z28 T56 I had rebuilt 2 years ago could not take the torque.So I'm in the search of T56 specialists that can make sure this doesn't happen again. I live in Atlanta area. I did find T56rebuilds.com in TX but was hoping there was someone local. The trany is already out.
Thanks in advance.
Registered User
Joined: Jan 2002
Posts: 206
From: San Antonio
Re: T56 Rebuild
Rockland Standar Gear. www.rsgear.com
These guys are the best, in my opinion. They can do anything you want to the trans.
These guys are the best, in my opinion. They can do anything you want to the trans.
Registered User
Joined: Aug 2004
Posts: 107
From: Cedar Park, TX
Re: T56 Rebuild
Might also try Jennings Race Performance:
http://www.jenningsengineering.net/fbody.htm
They're building one for me right now....the price is right and Chris has been great to work with.
http://www.jenningsengineering.net/fbody.htm
They're building one for me right now....the price is right and Chris has been great to work with.
Thread
Thread Starter
Forum
Replies
Last Post