Searched the forum, but not much turned up. I went out and had a friend shoot a burnout video of my Z28 today. Well, on the first take, I get going and he's on my driver's side and he says "I thought this had a posi" and I thought it did too. Was I wrong? Or is something else wrong with the car? I'm somewhat concerned. I don't burnout often. I'll spin the tires, but I've only ever done 2 brakestands. Any info would be great. If something does need to be fixed or replaced, what do you recommend and how much will it cost me?

Thanks for any info.

Kris

 

Well!!!!
Is it spinning both tires?????

 

Was there suposed to be a video attached to this??

 

im sure hes intending i only spun one... i had that happen to my 00z... took rear apart to replace axles, and it fixed it...(may have been fixed before, but didnt check...)

cory

 

Sorry, I didn't mean to make it sound like there'd be a video attached. But no, only one wheel is spinning, and it's the passenger side one. I notice a clunking whenever I hit a bump with the car. I thought it was maybe the exhaust banging against the bottom of the car (and it may still be just that) but I noticed it a bit more today after the burnouts yesterday. Could it be something to do with my rear end?

Kris

 

posi is probably just worn out, it happens. I'd change the fluid/additive and see if it helps any, but you're probably looking at a worn out posi unit.

 

If it has posi from the factory it will have a g80 code on the sticker in your glove box

 

I'll take a look at lunch time. So there were non-posi Z28's too?

 

Had to run out to the car for my cell phone and took a quick look. Sure enough, the G80 code is there....crap. Looks like a busted or worn out posi. Oh well...

 

All 4th gen Zs had positraction as standard equipment.

 

so was the 273 geared rear ends posi too ?

 

yes

 

Camaro Z28.com, where you learn something new every day.

 

Hence the word "all" in my previous post.