Need help with 6M removal
Thread Starter
Registered User
Joined: Jun 2004
Posts: 148
From: Fairview NC (near Charlotte)
Need help with 6M removal
I am trying to install a new clutch on a 1997 LT1 car and we can't get the transmission out of the car
with it let all the way down the top of the trans hits the body of the car in the transmission tunnel
it will only go back about 1 inch
I even jacked up on the front of the car to make it flex down in the center a litte and it did not help I tried to take the trans loose from the bell housing and I can't get the throwout arm loose
any help would be nice
with it let all the way down the top of the trans hits the body of the car in the transmission tunnel
it will only go back about 1 inch
I even jacked up on the front of the car to make it flex down in the center a litte and it did not help I tried to take the trans loose from the bell housing and I can't get the throwout arm loose
any help would be nice
Last edited by Darren P; Aug 7, 2004 at 11:09 AM.
anyone please 
Administrator
Joined: Nov 1998
Posts: 71,110
From: Hell was full so they sent me to NJ
Re: Need help with 6M removal
When you say you "jacked up on the front of the car to make it flex down in the center a litte" do you mean you jacked the front of the engine, and the trans still didn't tilt down far enough to back it out? I've never seen one where that didn't work.
As far as the clutch fork, get it off the T/O bearing BEFORE you try and move the trans.
As far as the clutch fork, get it off the T/O bearing BEFORE you try and move the trans.
Thread
Thread Starter
Forum
Replies
Last Post
NewsBot
2010 - 2015 Camaro News, Sightings, Pictures, and Multimedia
0
Sep 14, 2015 09:20 AM
RX Speed Works
Supporting Vendor Group Purchases and Sales
0
Sep 11, 2015 03:31 PM
