Gear Ratio & Posi Unit Recommendations
Gear Ratio & Posi Unit Recommendations
I blew my set of 4.10s in my 95 stock rear end TA again after several years. With the 4.10s I have a grat 1/8th mile but run out of wind by the end. Best ET is 12.8 so far but the car hits a wall. Would I be better off with 3.73s?
As far as posi units - my stock unit is shot. I am looking for inexpensive recommendations. I assume to stay away from the cone Auburn units.
Thanks - Mike
As far as posi units - my stock unit is shot. I am looking for inexpensive recommendations. I assume to stay away from the cone Auburn units.
Thanks - Mike
Thread
Thread Starter
Forum
Replies
Last Post
chevroletfreak
LT1 Based Engine Tech
202
Jul 4, 2005 05:00 PM



