TPS code
Thread Starter
Registered User
Joined: Sep 2001
Posts: 831
From: Western North Carolina
TPS code
Got the tps code(low circuit) the other day and replaced it.The code was still there.The connector looked bad so I replaced it also.Still got that dang code. I have 5.05 at the reference wire and the black wire is showing ground.,what should the green wire have on it? 12v,etc. Does anyone have the wire colors to make sure the wires are connected correctly?Thanks
Last edited by Red97LT1; May 28, 2009 at 07:04 PM.
Registered User
Joined: Nov 2007
Posts: 910
Thought they were gray +5V ref from PCM, black ground ref from PCM, and dark blue signal to PCM. In any case the signal wire should be about 0.5V with IGN on TPS closed, and go to about 4.5V or slightly higher with TPS wide open. Is your TB stock, or have you modified it ?
Thread
Thread Starter
Forum
Replies
Last Post
edman
General 1967-2002 F-Body Tech
5
Jan 22, 2015 02:45 PM