Questions about pulling timing with the Traction Control tables
Thread Starter
Registered User
Joined: Feb 2004
Posts: 2,182
From: Moore OK
Questions about pulling timing with the Traction Control tables
In lt1edit the traction control tables only go up to 6400. If i do 5^ retard at 6400, will it just carry the 5^ for everything above that, or will it default to max advance?
Also, has anyone actually done a setup using the traction control input. I found one post with someone describing it, and one post with someone saying they couldn't get the right signal to the pcm. If so, do you apply ground or 12v to the input line?
Also, has anyone actually done a setup using the traction control input. I found one post with someone describing it, and one post with someone saying they couldn't get the right signal to the pcm. If so, do you apply ground or 12v to the input line?
Thread Starter
Registered User
Joined: Feb 2004
Posts: 2,182
From: Moore OK
Re: Questions about pulling timing with the Traction Control tables
I answered my own questions. Ground the input for traction control on the pcm, then anything above 6400 it will use the last cell specified.
Thread
Thread Starter
Forum
Replies
Last Post
Gtpguy
General 1967-2002 F-Body Tech
48
Jan 26, 2015 04:50 PM
chevroletfreak
LT1 Based Engine Tech
202
Jul 4, 2005 05:00 PM