More closed loop parameter questions ....
Thread Starter
Registered User
Joined: Feb 2001
Posts: 1,081
From: Charleston, WV, U.S.
More closed loop parameter questions ....
....from my main thread ....
Anyway, I noticed a couple things in my version of LT1 Edit that may allow me to run closed loop and keep learning out of the surge range. There is a "minimum MAP for BLM update" and I raised it to 50 (MAP is basically KPA right?) to get learning out of the <50 KPA areas where I see surge. There is also a "WOT BLM = 128, yes or no" that I have selected as "yes" .....I assume this is basically a BLM locker. I did not see anything that says anything about locking max and min to 128 except for enable temps, is this what everyone's talking about concerning limiting the BLM's ability to integrate fuel?
Anyway, I noticed a couple things in my version of LT1 Edit that may allow me to run closed loop and keep learning out of the surge range. There is a "minimum MAP for BLM update" and I raised it to 50 (MAP is basically KPA right?) to get learning out of the <50 KPA areas where I see surge. There is also a "WOT BLM = 128, yes or no" that I have selected as "yes" .....I assume this is basically a BLM locker. I did not see anything that says anything about locking max and min to 128 except for enable temps, is this what everyone's talking about concerning limiting the BLM's ability to integrate fuel?
Thread
Thread Starter
Forum
Replies
Last Post
Sergio
LT1 Based Engine Tech
11
Jan 27, 2016 04:27 PM
armedtrigger
LT1 Based Engine Tech
10
Feb 24, 2015 08:30 PM
ChrisFrez
CamaroZ28.Com Podcast
0
Feb 1, 2015 08:26 AM
ChrisFrez
CamaroZ28.Com Podcast
2
Dec 7, 2014 06:01 PM