Checked out my cable ... is this right ?
Thread Starter
Registered User
Joined: Jul 1999
Posts: 224
From: Holland
Checked out my cable ... is this right ?
I have an original AKM DLC cable.
Simple setup:
Comport - RS232 cable == INTERFACE UNIT (serial#307) === RS232 - OBD1 conn cable
Bought it used only to find out that i needed an OBD2 connector.
Now, i was thinking of changing that myself as it would require an OBD2 connector and connecting the right wires.
I opened the RS232 connector and noticed that there are ONLY 2 wires connected (pin 1 red wire and pin 5 white wire) that lead to the OBD1 connector that has 5 pins in total (probably some internally connected).
Are these 2 wires enough to rig it up to an OBD2 connector ???
P.s. 2 other wires were connected to that same RS232 connector at pin 22 and 25 BUT they are cutoff and don't lead to any connector.
Anybody who understands this ??
Simple setup:
Comport - RS232 cable == INTERFACE UNIT (serial#307) === RS232 - OBD1 conn cable
Bought it used only to find out that i needed an OBD2 connector.
Now, i was thinking of changing that myself as it would require an OBD2 connector and connecting the right wires.
I opened the RS232 connector and noticed that there are ONLY 2 wires connected (pin 1 red wire and pin 5 white wire) that lead to the OBD1 connector that has 5 pins in total (probably some internally connected).
Are these 2 wires enough to rig it up to an OBD2 connector ???
P.s. 2 other wires were connected to that same RS232 connector at pin 22 and 25 BUT they are cutoff and don't lead to any connector.
Anybody who understands this ??
Thread
Thread Starter
Forum
Replies
Last Post
Darth_tsunami
V6 Tech
6
Sep 18, 2015 01:57 AM
Redbird
Drag Racing Technique
3
Sep 14, 2002 09:18 AM