Can I make a Man.Fan. Switch with this switch?
Thread Starter
Registered User
Joined: Dec 2003
Posts: 1,457
From: Seattle, Washington
Can I make a Man.Fan. Switch with this switch?
Its an ON - OFF - ON switch...
The back on it looks like this...
- Accessory (Top)
- Supply Volts (Middle)
- Accessory (Bottom)
Is there any way possible I can make a Man.Fan. switch with just that switch as it's just the right size and I can't fit anything larger on the panel... I am willing to use Relay's if need be but I need information on where to route all the wiring.
The back on it looks like this...
- Accessory (Top)
- Supply Volts (Middle)
- Accessory (Bottom)
Is there any way possible I can make a Man.Fan. switch with just that switch as it's just the right size and I can't fit anything larger on the panel... I am willing to use Relay's if need be but I need information on where to route all the wiring.
Last edited by Need4Camaro; Jan 27, 2006 at 10:31 AM.
Registered User
Joined: Dec 1969
Posts: 27,725
From: Little Rock, AR
Re: Can I make a Man.Fan. Switch with this switch?
If the fan wiring is the same as LT1 years, you can use wiring diagrams on my Tech Page. You need a DPDT switch. The switch you describe could be a DPDT or SPDT (dual pole or single pole, double throw).
Thread
Thread Starter
Forum
Replies
Last Post
PFYC
Supporting Vendor Group Purchases and Sales
0
Jan 23, 2015 01:13 PM
chevroletfreak
LT1 Based Engine Tech
202
Jul 4, 2005 05:00 PM
Rich_z28
Car Audio and Electronics
3
Aug 29, 2002 10:44 PM