Low Mileage TPI Trans Am, Ohio/PA, Sell or Trade
#1
Low Mileage TPI Trans Am, Ohio/PA, Sell or Trade
Im gonna give it another shot before winter.
pics:
http://www.cardomain.com/ride/2136151/1
1990 Pontiac Trans Am
45K miles- Im the 3rd owner
305 TPI, 700R4, 3.42 Posi, WS6 Suspension, TTops
Recently had new brake pads, spark plugs,wires,cap&rotor, o2 sensor, alternator, and K&N filter.
Body and interior are in above average condition. There are a few small scratches, and I think two very small dings. The fiberglass spoiler has two small cracks that are hard to see. It has a Flowmaster 40series welded on in place of the cat.
The problems:
The A/C needs recharged or converted to R134
the 3.42 posi rear I put in needs new wheel bearings. I still have the 2.73 posi rear that has nothing wrong with it, I will include it if wanted.
I put a cheap oxygen sensor on, so it sometimes throws the code 45 when at cruising speed. No big deal.
The muffler sits low to the ground and sometimes scrapes. Im also not the best welder so there were a couple spots I missed and had to Quicksteel. When the muffler sracpes real bad it breaks some of the Quicksteel off and makes a small exhaust leak. The car sounds real good though.
Its an extremely nice car with no rust at all anywhere on the body, even underneath. Never in any snow and very little rain. Always garaged and covered. NADA value is $5600, but Ill go a little bit lower than that.
I will consider partial trades for a 350 FBody or 305/350 GBody in fair to good condition. But I have to get some cash with the deal, I cant trade straight up.
Im in Youngstown,Ohio, which is in the northeast corner.
pics:
http://www.cardomain.com/ride/2136151/1
1990 Pontiac Trans Am
45K miles- Im the 3rd owner
305 TPI, 700R4, 3.42 Posi, WS6 Suspension, TTops
Recently had new brake pads, spark plugs,wires,cap&rotor, o2 sensor, alternator, and K&N filter.
Body and interior are in above average condition. There are a few small scratches, and I think two very small dings. The fiberglass spoiler has two small cracks that are hard to see. It has a Flowmaster 40series welded on in place of the cat.
The problems:
The A/C needs recharged or converted to R134
the 3.42 posi rear I put in needs new wheel bearings. I still have the 2.73 posi rear that has nothing wrong with it, I will include it if wanted.
I put a cheap oxygen sensor on, so it sometimes throws the code 45 when at cruising speed. No big deal.
The muffler sits low to the ground and sometimes scrapes. Im also not the best welder so there were a couple spots I missed and had to Quicksteel. When the muffler sracpes real bad it breaks some of the Quicksteel off and makes a small exhaust leak. The car sounds real good though.
Its an extremely nice car with no rust at all anywhere on the body, even underneath. Never in any snow and very little rain. Always garaged and covered. NADA value is $5600, but Ill go a little bit lower than that.
I will consider partial trades for a 350 FBody or 305/350 GBody in fair to good condition. But I have to get some cash with the deal, I cant trade straight up.
Im in Youngstown,Ohio, which is in the northeast corner.
Thread
Thread Starter
Forum
Replies
Last Post
Moshbmx1
Parts For Sale
1
01-20-2015 03:27 PM