FS or Trade:11sec 1987 Buick T Type
FS or Trade:11sec 1987 Buick T Type
Black w/ blue metallic flakes and blue vinyl top. Very good condition with about 100,600 miles on body, 8,000 on motor, trans, and rear end, and about 3,000 miles on turbo and intercooler. grey interior with bucket seats, power door locks, tilt steering, and cruise control. It's a fairly low optioned car. A/C blows ice cold and the heat will burn you out. everything works. this is not a perfect car but it is in wonder shape. no body damage or rust anywhere, and has a clear car fax. I have well over 18k invested in this car but will make a sacrifice for $10,000obo. Will consider all trades.
pics can be seen here: http://www.putfile.com/ricekilla/images/17947. must see to appreciate. gets attention everywhere i go
mods: this is a solid 11sec setup
john craig te44 turbo, pte stock location intercooler, arp studs in the top and bottom end, 208 208 cam, ported and polished heads, 3 angle valve job, 50lbs msd injectors, 93 street chip and 110 race chip, 3" terry houston down pipe with dump pipe, 100lbs valve springs, roller timming chain, 160 t stat, k&n cold air, scanmaster, walboro 255, hotwire kit, quad air volt booster, rebuilt tranny with shift kit, 3000 stall converter, detroit locker w/ stock 3.42s, boxed upper & lower control arms w/ poly bushings, air bags in rear suspension, and 275/50/15 bfg drag radials
pics can be seen here: http://www.putfile.com/ricekilla/images/17947. must see to appreciate. gets attention everywhere i go
mods: this is a solid 11sec setup
john craig te44 turbo, pte stock location intercooler, arp studs in the top and bottom end, 208 208 cam, ported and polished heads, 3 angle valve job, 50lbs msd injectors, 93 street chip and 110 race chip, 3" terry houston down pipe with dump pipe, 100lbs valve springs, roller timming chain, 160 t stat, k&n cold air, scanmaster, walboro 255, hotwire kit, quad air volt booster, rebuilt tranny with shift kit, 3000 stall converter, detroit locker w/ stock 3.42s, boxed upper & lower control arms w/ poly bushings, air bags in rear suspension, and 275/50/15 bfg drag radials
Thread
Thread Starter
Forum
Replies
Last Post
WobblySausage
LT1 Based Engine Tech
6
Oct 7, 2015 02:44 PM
CARiD
Supporting Vendor Group Purchases and Sales
0
Sep 30, 2015 05:44 AM
surreybrad
General 1967-2002 F-Body Tech
1
Sep 29, 2015 09:00 PM
autoxr166
General 1967-2002 F-Body Tech
0
Sep 25, 2015 04:21 PM



