I asked the below question on 4 different forums with no replies so I'm hoping I can get a reply here.

SLP doesn't offer the WS.6 logo on their car covers, why I do not know since for a few years they did do conversions, but anyway I'm going to buy a non embroidered SLP cover & have WS.6 embroidered on it.

What I need is the height & width of the SS embroidered SLP covers & how high from the bottom it sits from those of you have have one.

Thanks.

 

You might try this forum: http://www.chirpthird.com/ you may get an instant answer. Otherwise you'll have to wait until tomorrow.

 

That's because SLP didn't do the WS6, ASC did. SLP did the Firehawk.

I have an SLP SS car cover. If you still need the info, remind me in an e-mail, I will go out and measure it for you.

 

I still need it & SLP did do the early WS6's, really.
Then ASC got it.

 

I stand corrected, I forgot about that.

I got your measurements from my cover:
The Camaro SS logo is approximately 18" wide, 5" high and 18" up from the front bottom edge.

 

Thanks.

I'm guessing the 18" up means from the bottom of the SS lettering to the seam of the cover?

 

Correct.