just picked up a SD vortec base to convert back to tpi and i've forgotten what else i need on the base to keep things up to date with my Speed density setup.

i picked up a 2 prong engine coolant temp ecm sensor, gasket and blockoff plate for the egr and a 1/2" npt coolant hose fitting but i can't remember what other fittings/sensors went on the base intake.

i don't have emissions equipment but everything else is the same. anyone have a picture of a stock tpi base intake that i could see to figure out what fittings go where?

 

sounds like you have everything, the ECT went right in the front, the coolant nipple went in the port aimed to the pass side at the front

 

that's all i can think of, so it sounds right then...? can't wait to get this thing back on the road, i want to dyno it right away as well and see what the miniram really did for it.