91z28man

Ok Ok, I guess I went a little big. But i just want that racy sound chug chug u know. What about this kit:

http://store.summitracing.com/partde...=KeywordSearch

Or just a roller cam from crane what would I have to do to get this to work!

http://store.summitracing.com/partde...=KeywordSearch

bubba353z

Now you're in the right neighborhood.....

Take a look at the Comp Cams 303/304/305 for computer controlled vehicles:

Comp Catalog

Page 146. Those are nice, moderate cams - I'm running the 305.

I'd stick with the roller cams - they may cost more, but will make more power. You're already set up for it, so might as well take advantage.

91z28man

I was thinking the compu cam and getting a chip burned for it. So all I need is a single roller cam, and the stock pushrods and lifters set up for roller will be fine.

bubba353z

That will work. You'll get a nice power bump and still be able to drive it daily. You can reuse the roller lifters and pushrods, with this cam. Check the mfg. valve spring requirements for any new cam. You should be OK with stock springs, but I won't swear to it.

91z28man

Cool, would the 306 be too big.

bubba353z

It would be OK with a Stealth Ram or a heavily modded TPI + exhaust + Stall convertor. A lot of guys are running them.