DirtyDaveW

Hotside (tubular manifolds) and Turbo(PT76GTS) are now fully installed. It has been so much fun(?) laying in the mud and melting snow (god I wish I had a garage). Thankfully, I bought a kerosene 'Torpedo' heater last year so I've been getting some good usage out of that.

What's left to do...

• put starter back on
• Tighten steering coupler to steering mast
• route the vacuum lines to the new wastegate
• install alternator/power steering
• Reroute the power steering lines
• complete the intermediate pipe from the end of the down pipe to the Borla pipe(all down the passenger side)
• modify the current cold side to match the new turbo outlet positioning.
• Find a good place to place the air filter.
• Route the narrow and wide band O2 sensor wires.

Also, just wanted to give Jon (Realquick/Lt1boost.com) and big thumbs up on fitment. This is a complex kit and all the flanges/positioning are lining up perfectly!

rwb

When you are done and make a good run down the track it will all have been worth it.