n20 pressure gauge

How many of you have a mech nitrous pressure gauge installed in your a-pillar? if so, how should i go about installing this? any tips/tricks you guys can offer me?

its not hard. The only problem will be getting the gauge to sit flush in the pod. To do this I suggest you cut one of the U brackets that comes with the gauge and attach it to the side where the line comes in. Then you can just tighten the nut to get it to sit flush. Everything else is pretty easy. Let me know if you need anymore help, oh too bad I just left ft lauderdale or I could help you

How long of a line did you guys run and where did you run it?

I ran a 12' line from the bottle to the a-pillar. You need about 8' to go from the solenoid

yup 8 feet sounds about right....from solenoids