changing U-joint / yoke bearings on a 94'Camaro drive shaft
Thread Starter
Registered User
Joined: Mar 2003
Posts: 43
From: Germany
changing U-joint / yoke bearings on a 94'Camaro drive shaft
Hello!
With my installed BW t56 in a 69'Camaro I want to use the slip yoke / U-joint from the same donor car, a 94'Camaro LT 1. I want to renew the bearings but I noticed that they are not hold by clamps or something else I think they are fixed with injected plastic.
How could I change these bearings?
With my installed BW t56 in a 69'Camaro I want to use the slip yoke / U-joint from the same donor car, a 94'Camaro LT 1. I want to renew the bearings but I noticed that they are not hold by clamps or something else I think they are fixed with injected plastic.
How could I change these bearings?
Administrator
Joined: Nov 1998
Posts: 71,122
From: Hell was full so they sent me to NJ
The plastic has to be melted out of the joint. I found it easiest to just take the shaft to a local auto shop and have them take it out for $10.
Moving to "Drivtrain" forum. "LT1 Based Engine Tech" is only for "engine" topics".
Moving to "Drivtrain" forum. "LT1 Based Engine Tech" is only for "engine" topics".
Thread
Thread Starter
Forum
Replies
Last Post
squarehead
General 1967-2002 F-Body Tech
0
Nov 21, 2014 08:02 PM
chevroletfreak
LT1 Based Engine Tech
202
Jul 4, 2005 05:00 PM