3.4L Headers

Ok....so I'm cheap.....

Are the pacesetters the cheapest headers made for the 3.4L's. If not, which ones are cheaper?

I have a buddy that will do powder coating for me for a good price so I don't really care about how good the coating from factory is. He sprayed some on a piece of scrap metal, baked it and then beat the crap out of it with a hammer. Dented the metal but didn't chip the coating at all. Very sweet.

In JCWhitney, it says that some fabrication could be required. Those of you who put them on, what does that entail?

Thanks in advance!

pacesetters from what ive seen and heard are pretty decent headers...the ones for the lt1 arent bad at all...so im thinking they should be ok for you as well...for the price, its good aint it?

Best header out there for the 3.4 as far as I know.The Y-pipe is the only thing I know of that may need a little work.
Kevin

www.geocities.com/generationxracing/MainPage


don't know much about them, but they are much cheaper

Yes, the Pacesetters are about the cheapest out there. And as was mentioned above, the Y-pipe mating flanges need some work for best sealing.