Demon SS
05-12-2006, 05:49 PM
Well we got tired of using the chassis engineering swing out kits so one of my guys here decide to fab up a little something. We really like the way they fit and the way they look while the door bar is in and out of the car. Below are a few pictures of the door bar slugs and the o ringed caps that go over them. I will get a few install pictures of them in the car a little later.
We will be selling these for $160
What it will come with is:
4 Steel Slugs w/ .375 holes
2 Aluminum caps w/ o-rings for snug fits
4 Detent locking pins
Install instructions
If you already have a 6 point cage in the car with solid bars this would be about a 2-3 hour istall.
Only tools you would need are a welder (Tig for a better look), Sawzall, and a drill.
If you are really into looks you can add two more caps to the kit for the floor slugs for $30.
We curently have 10 sets in stock and will have more soon.
thanks
Brad
not sure how to post pictures on here so this will do for now.
http://www.ls1tech.com/forums/showthread.php?p=4804219#post4804219
We will be selling these for $160
What it will come with is:
4 Steel Slugs w/ .375 holes
2 Aluminum caps w/ o-rings for snug fits
4 Detent locking pins
Install instructions
If you already have a 6 point cage in the car with solid bars this would be about a 2-3 hour istall.
Only tools you would need are a welder (Tig for a better look), Sawzall, and a drill.
If you are really into looks you can add two more caps to the kit for the floor slugs for $30.
We curently have 10 sets in stock and will have more soon.
thanks
Brad
not sure how to post pictures on here so this will do for now.
http://www.ls1tech.com/forums/showthread.php?p=4804219#post4804219