Lm & Cme Valance?

Hey all i want to get LM for my car, but i like the look of CME, i was woundering if there is a way to get the LM to fit in the CME valance? I realize that it will be a tight fit, just woundering if i can have it done at my Local muffler shop...casue i really dont know where else to take it..lol

:confused:

Yes, its possible. You'd just have to make a couple bends in the LM tailpipes.

Yes, its possible. You'd just have to make a couple bends in the LM tailpipes.

But would a regular exhaust shop be able to do it? I realize that for it to look good i would have to swap it back to the stock tips..the way LM sets up is there is the passenger side pipe that shoots out strait after the resinator, then the drivers side one is kinda L shaped...i would think that they would have to add on pieces for it to work? Some times i think it would just be easier to get the quad exhaust kit, but i dont really want 4 tips just 2

:confused:

Any exhaust shop should be able to do it. Like I said, it's just a couple bends