lt1 vortech guys, I need pics

can someone take some pics of the underside of there vortech kit installed

i need to see where the filter went and and the pipeing, (around the swaybar etc)

I don't have a digital camera, so I'll try to describe it.

First, mark and drill the holes for the aluminum bracket for the plastic pipe that connects to the MAF. This installs square on the driver's side frame rail. Then, install the plastic pipe and the aluminum bracket with the four supplied screws. There are two small ridges on the pipe that will indicate where it goes in the bracket. For reference, the MAF end should angle slightly towards the front of the car.

Then, install the elbow on the supercharger and point it almost straight down. You'll have to angle it slightly to get the best clearance.

Install the sway bar.

Install the dryer ducting. It should run from the supercharger 90, under the sway bar (closer to the ground), then connect to the MAF plastic tube.

Hope this helps.

Mike

Originally posted by engineermike
I don't have a digital camera, so I'll try to describe it.

First, mark and drill the holes for the aluminum bracket for the plastic pipe that connects to the MAF. This installs square on the driver's side frame rail. Then, install the plastic pipe and the aluminum bracket with the four supplied screws. There are two small ridges on the pipe that will indicate where it goes in the bracket. For reference, the MAF end should angle slightly towards the front of the car.

Then, install the elbow on the supercharger and point it almost straight down. You'll have to angle it slightly to get the best clearance.

Install the sway bar.

Install the dryer ducting. It should run from the supercharger 90, under the sway bar (closer to the ground), then connect to the MAF plastic tube.

Hope this helps.

Mike

thank you it does help

anyone with pics ?

how can i move the maf to the discharge?
the tubeing is 2 long

You have to cut the intake elbow down, I cut the plastic tube a little bit and about an inch and a half off the intake elbow to make it fit. I will get pics tomorow when I can.

BAM !!!

http://fisher.osu.edu/~jshoberg/blower2.jpg

As 96WS6 said you have to cut down the elbow to fit the MAF on the pressure side. If you have the Vortech cooler then you have to go a bit further. Take a look at my site. It has a number of shots of the intake tubing I made from the blower to the intercooler and to the inlet.

Originally posted by [JFS]
BAM !!!

http://fisher.osu.edu/~jshoberg/blower2.jpg
>What size cog setup is that and how much boost are you seeing ?

>So where are the pictures ?