CamaroZ28.Com Message Board
0 2020/02/28 18:24:49
0 2020/03/16 07:53:50
0 2020/09/08 19:38:53
0 2020/09/11 10:30:27
0 2020/09/11 10:30:32
0 2020/09/11 10:48:07
0 2020/09/11 10:49:22
0 2020/09/11 22:07:36
0 2020/09/11 22:07:47
0 2020/09/11 22:07:57
0 2020/09/11 23:07:05
0 2020/09/19 16:53:08
0 2020/09/27 13:27:57
0 2020/09/27 13:28:03
0 2020/09/27 13:39:40
0 2020/09/27 13:49:42
0 2020/09/27 13:49:54
0 2020/09/28 16:57:41
0 2020/09/28 17:01:46
0 2020/09/30 07:52:28
0 2020/10/17 19:36:52
0 2020/10/17 19:39:26
0 2020/10/23 13:29:36
0 2020/10/23 16:06:03
0 2020/11/04 15:45:23
0 2020/11/05 06:18:41
0 2020/11/05 17:37:04
Oil cooler removed with lines and hoses attached. Also started to cut the heads off the studs on the bolts that mount the adapter plate shown on the left above the bolts.
Oil cooler removed with lines and hoses attached. Also started to cut the heads off the studs on the bolts that mount the adapter plate shown on the left above the bolts.
0 2020/11/05 17:38:51
View of adapter plate still bolted to the block with studded bolts. Cutting the studs off the heads of those two bolts allow them to be reused to mount the adapter plate and not interfere with your oil filter installation.
View of adapter plate still bolted to the block with studded bolts. Cutting the studs off the heads of those two bolts allow them to be reused to mount the adapter plate and not interfere with your oil filter installation.
0 2020/11/05 17:42:20
0 2020/11/05 17:44:53
The stud portion of the bolt removed.
The stud portion of the bolt removed.
0 2020/11/05 17:46:09
K&N Oil filter installed hand tight after putting some oil on the seal and pouring some in the filter.
K&N Oil filter installed hand tight after putting some oil on the seal and pouring some in the filter.
0 2020/11/05 17:47:31
0 2020/11/05 17:49:20
0 2020/11/05 17:50:43
Connector removed and replaced. For the MAP connector, you need the longer extractor onnthe tool because the terminal locks are deep in the connector housing.
Connector removed and replaced. For the MAP connector, you need the longer extractor onnthe tool because the terminal locks are deep in the connector housing.
0 2020/11/16 16:34:53
Terminal release tool.
Terminal release tool.
0 2020/11/16 16:34:59
Terminals that were extracted from the pigtail I ordered from Amazon.
Terminals that were extracted from the pigtail I ordered from Amazon.
0 2020/11/16 16:35:05
0 2020/11/21 07:19:14
0 2020/12/16 17:03:20
0 2020/12/23 11:25:39