Time to make my street car more of a race car and I need $$ to finish it
383/ TH350
Motor has about 5000 miles and 60 or so passes and heads are new with about 12 passes and 50 miles street time. If you live close to DFW you can here it run. In a 3200-3300 lb car this is an easy 11 sec motor. Compression is 10.3+ and runs great on 93 runs 7.60s-7.70's my my heavy *** 3500 lb Malibu

What I have........
Holley 750 DP
Performer RPM intake
GM Performance polished valve covers
Dart Iron Eagle heads 200cc 2.05/1.60 ported flow 277/199 @.600 @28" Ported by Lloyd Elliot
Ferra valves
Harlan Sharp roller rockers
manley 1 piece pushrods
Crower "hydraulic hauler" cam .500/.518 232/242 @50 on 108
Scat nodular cast crank
5.7 GM rods resized with ARP bolts
Speed Pro hyperutectic flat top pistons
block bored/honed with plates and decked to .004 in the hole
fully balanced externally
moroso oil pump drive
melling std vol pump with high pressure spring
GM pan
gm balancer


Motor carb to pan $2300.00

less carb intake and valve covers $2100.00

short block $800.00

TH350 with 10" ATI street master $450.00

2.5" X pipe exhaust with dynomax ultraflows and full tails G-Body/ Malibu $300.00

Stock Ford 9" case with 31 spline aurburn pro- serries carrier and 4.10 gear $400.00