Gauging interest... 99 h/c/nitrous TA
#1
Gauging interest... 99 h/c/nitrous TA
I've only had the car since thanksgiving. Its a bad *** car and I love it, but right now its just not practical. Im not 100% set on selling it, but im considering it if someone is interested. It has 114k miles. I, nor the previous owner have ever beat on the car. The car was in the september 07 issue of high performance pontiac and is in great condition. Also, the nitrous was only used to get dyno numbers for the magazine. If interested, let me know. $11.5k obo. Heres a run down of the mods/a few pics.
limo tint on the rear/side windows
10in sub/stealth box/amp
18x9 boyd coddington smoothie 2s with bfg tires (~80% tread left)
RPM stage 3 LS6 Heads
2.02/1.60 valves, been ported on both intake and exhaust side, milled .030
Crane dual springs good to .650 lift
RPM 4 .595/.601 232/236 114lsa.
100 shot NOS dry shot/ purge etc.
A-pillar pod with autometer ultralite fuel pressure/nitrous pressure/ a/f ratio
Raptor shift light
Hooker LTs, 3in. TD with ORX, bullet mufflers dumped at the
BMR Sway bars, LCAs, relocation brackets, sub frames, etc
Hotchkis PHB
Eibach sportlines
LS6 intake
SLP lid and bellows, NGK plugs, SVO Green Top 42lb injectors, LS1 EDIT done by RPM
LS7 clutch/pressure plate/LS2 flywheel
pics..
limo tint on the rear/side windows
10in sub/stealth box/amp
18x9 boyd coddington smoothie 2s with bfg tires (~80% tread left)
RPM stage 3 LS6 Heads
2.02/1.60 valves, been ported on both intake and exhaust side, milled .030
Crane dual springs good to .650 lift
RPM 4 .595/.601 232/236 114lsa.
100 shot NOS dry shot/ purge etc.
A-pillar pod with autometer ultralite fuel pressure/nitrous pressure/ a/f ratio
Raptor shift light
Hooker LTs, 3in. TD with ORX, bullet mufflers dumped at the
BMR Sway bars, LCAs, relocation brackets, sub frames, etc
Hotchkis PHB
Eibach sportlines
LS6 intake
SLP lid and bellows, NGK plugs, SVO Green Top 42lb injectors, LS1 EDIT done by RPM
LS7 clutch/pressure plate/LS2 flywheel
pics..
Thread
Thread Starter
Forum
Replies
Last Post
RX Speed Works
Supporting Vendor Group Purchases and Sales
0
09-11-2015 03:31 PM
jackpawt883
LT1 Based Engine Tech
7
09-10-2015 08:53 PM
[Interior] Interior protection
themex2002
2010 - 2015 Camaro Interior, Exterior, Paint & Body, Electronics/Car Audio
1
09-02-2015 03:47 PM