I need to source some parts for a non Fbody. They're for my 98 SVT Contour (engine wiring harness).

Where are some junkyards in DFW that have a wider range or parts? There weren't too many made like my car.

Also, what tools should I bring? I haven't been to one since I was in highschool...

 

bring a craftsman 95 peice socket set. some pliers and a couple screw drivers. and for your svt your prob best looking through online yards. do you need a whole harness? or can the prob be fixed?

 

no dude, it's toast.

There's about a 12" section where the insulation has completely rotted off and several wires are broken. It's just totally falling apart.

I've found a couple online, but I've got the day off tomorrow anyhow so it's worth a shot. FWIW, I think the SVT uses the same part as the regular v6 cars. Do you know of any decent bone yards to try?

 

id hit up als atomic. it seems to have the largest selection of cars that ive seen.

 

I would check out the wrecking yards on Elliott Reeder road in Fort Worth.

My favorite ones are Dismantlers, Packs, and Little Johns.

Dismantlers is huge and has everything.

Packs has a lot of late model stuff.

Little Johns has down sized (more into recycling metal) but does have a variety of cars. If they have what you want they will be the cheapest.

Worst case senerio is going to Glenn and Jerrys. I hate the place. They have late model stuff but are always rude and pricey.

 

That's what I would do too. Been down there many times.