Without going into great detail, a couple of years ago I hit a large rock with the camaro and put a very large dent in the k-frame. I am getting ready to pull the motor out, and would like to check some measurements to see if it has been tweeked. I dont want to run into issues with alignment and engine / drivline angle. I assume that a body shop might have the measurements but I wanted to check here first.

Thanks.

 

Ttt

 

what do you want hole tohole or pin to pin???

 

Quite honestly, I am not sure where are the good points to measure from. I am open to anything. Thanks for replying. I know that this is an unusual request.

 

hey what parts of Va. you in? how far from richmond?

I have a stock v-8 k-member

 

I am interested. I don;t want to deal with something that is bent up and have it bite me later. Especially if I have the motor out. PM my your price.
I live behind Dulles Airport so you are a bit of a distance. However, I do spend time at Lake of the Woods (in-laws lake house) in Orange near Fredricksberg which is sort of halfway. Maybe we can coordinate it during one of our visits.

 

You can cut through orange to louisa, I'm the next county over.

If I head to budds creek anytime soon I will let you know and take it with me. MIR.....know where it is?

 

Hey, that sounds good. I need an excuse to go the track! What do you want for it?