I have a Flowmaster Cat back on my Z28 and I want to replace the muffler with a Magnaflow. ANyone know what size it would be and where I can get it at? Thanks A lot

Mike

 

Try LS1speed.com they probably have them

As for size, if it's stock piping it should be a 2.5" in

Jeg's would also have it

 

Well since I have a flowmaster catback on the car, it would be 3" in and dual 3" out. I just dont know what the length is. ls1speed doesnt stock magnaflow and jegs only has 3" in and dual 2.5" out.

 

go here-HottExhaust.com.got mine there.replaced the corsa with it when i found out i have to sell my car.cost me like 90 bucks for an aluminized one including shipping.part no. is 12267.it on page 6 of the aluminized muffler section.

 

I was thinking about that one, but i was going to hold out and see if anyone knew if they made a 3" in/dual 3" out muffler....if not that will have to do. Thanks though.

 

www.summitracing.com

they have some pretty cheap prices for magnaflow and dynomax

 

www.exhaustproslinc.com

Part #12267

 

OK I know about the 12267 P/N muffler. I was curious about a 3"in/dual 3" out muffler. Do they make one that will fit or am I going to have to get the muffler above...I'm guessing the one above since everyone keeps telling me about....

 

Try part #14298 its a 3/3 single in dual out

 

Hey I have one sitting in my garage....if you want it let me know. It still has tailpipes and everything attached, but I can cut them off.

 

how much?

 

how much?

 

I'll sell you a complete magnaflow catback for $275 shipped. I has the polished stainless muffler and polished stainless 3.5 tips. It was on my car for less than 500 miles. I'm upgrading to the GMMG catback. I also take PAYPAL. You can email me at curt96ws6@hotmail.com

Thanks,
Curt

 

Why don't you try the TECH section?

 

I'll sell the muffler for $45, and $70 w/Megs stainless tips and the tailpipes all welded on and ready to go.