GM 10 bolt 7.5 Rear End Girdles on sale !!!!

$122.95 SHIPPED !!!!!! Only at www.neweraperformanceparts.com

Strengthen your GM rear end with the strongest rated support covers you can buy !! These 356 T-6 Aluminum covers help keep the rear end housing from distorting under load , preventing increased side bearing clearance and ring gear deflection . Two special adjustable grade-8 support bolts help prevent both bearing main caps from movement and possible breakage . Increased fluid capacity , fill , drain plugs and hardware .

While supplies last !!!

Thanks ,
Mike
www.neweraperformanceparts.com
sales@neweraperformanceparts.com
585-865-1832

 

www.neweraperofmanceparts.com
WHOOPS

 

Whoops !!! Thanks , that website address is too long !!!


Thanks ,
Mike
www.neweraperformanceparts.com
sales@neweraperformanceparts.com
585-865-1832

 

so is this just a replacement basically, same as stock just better, or is it a differnt one all together, i dont know much about these cars yet...

 

It is definitely different than the stocker , it will strehgthen the rearend by putting pressure on the Main bearing caps , and allow you to drain and fill the rear end without pulling the cover , and supposedly give off heat through the ribs allowing a slightly cooler operating temperature inside .

Mike
www.neweraperformanceparts.com
sales@neweraperformanceparts.com
585-865-1832

 

what i mean is, will it work in place of the stock one, or would i have to change other things as well?

 

these include the bolts?

 

Yes , it is a direct replacement for the stock cover .

Yes , it comes with new bolts and a new gasket as well . It really is a pretty nice piece .

Thanks ,
Mike
www.neweraperformanceparts.com
sales@neweraperformanceparts.com
585-865-1832

 

Mike I wont have to take this to a garage or anything, it just unbolts right? Just making sure, kinda still new to the car world. Anybody can answer that question.

 

Mike I wont have to take this to a garage or anything, it just unbolts right? Just making sure, kinda still new to the car world. Anybody can answer that question.

 

from what i am being told yup, just unbolts....but like u im new to all this as well.....

 

You will have to take off the old cover , then bolt the new one up and set the preload on the bearing caps and fill up your rear end with gear oil . I don't know if you would need to have a shop do this or not , if you need furhter assistance , you can call between 10am and 5pm mon.-fri.

Thanks,
Mike
www.neweraperformanceparts.com
sales@neweraperformanceparts.com
585-865-1832

 

how many do u have left??

 

7 Left right now .

Thanks,
Mike
www.neweraperformanceparts.com
sales@neweraperformanceparts.com
585-865-1832

 

do they look exactly like that link u posted a couple posts ago?