I need an M6 Transmission crossmember for the Turbo 400 I am going to install. 1993 through 1999 should work just fine, I just need to elongate the hole and fabricate a 1.5" aluminum spacer.


Thanks
Jim, Orlando Fl

jimadamsz28@hotmail.com

 

Do you have any plans for the T56?

 

ah, maybe you had better read the post again.


Jim

 

Doh! gotcha. Sometimes I'm kinda slow.

 

I posted this on the CFFB board as well.

I've got one off of a 96 Z28. I'm swapping the drive train out of the 96 Z28 into a Datsun 260Z so I won't be needing the crossmember. I'll make the price right it's yours for free. Email me at jmcelyea@nassal.com and we can swap phone numbers.

 

Hey Jeff,
I sent you an email with my work and cell telephone numbers.

One other thing: Just to let you guys know; I replaced the Transmission mount on my 1999 Z28 (too much torque, if that is possible) with a poly. The rubber one was trashed and the back of the tranny was rising up to the point that the ds was hitting the ds loop and it sounded like the whole rear of the car was coming out.
Anyway, the mount is good, the vibrations have picked up. I can even feel vibrations in the gas petal.

Later,
Jim

 

Had to pop up to Atlanta yesterday so I got your email this morning and sent you a reply with my contact information. I had a poly mount in mine for a while but I couldn't take the vibration and went back to a rubber one.