LT1/SBC roller lifters, ARP rocker studs, complete TPI intake/TB etc
Guest
Posts: n/a
LT1/SBC roller lifters, ARP rocker studs, complete TPI intake/TB etc
GM LT1 roller lifters. Used, good condition. Should work SBC and LS1's, too, from what I hear. Asking $100 OBO + shipping. I take Paypal or money order, PM me or e-mail blackwelljp@umsystem.edu.
Last edited by DropZ; May 16, 2010 at 04:15 PM.
Guest
Posts: n/a
More pics of lifters:
ARP 134-7101 rocker studs, 3/8" for SBC or LT1. Asking $30 OBO + shipping.
I have a complete TPI intake off my 89 L98 Trans Am, and a lot of little extras that go along with it. I have the lower intake with a SLP AFPR, runners, upper plenum, plastic distributor cover, throttle body, rubber hoses from TB to MAF and MAF to airbox, K&N filter for a stock airbox, fuel rails with stock injectors, and a full unused gasket set. I have a lot of the bolts, but I can't guarantee I have all of them. This would be a great conversion for a TBI or carbed car. Asking $100 + shipping OBO.
ARP 134-7101 rocker studs, 3/8" for SBC or LT1. Asking $30 OBO + shipping.
I have a complete TPI intake off my 89 L98 Trans Am, and a lot of little extras that go along with it. I have the lower intake with a SLP AFPR, runners, upper plenum, plastic distributor cover, throttle body, rubber hoses from TB to MAF and MAF to airbox, K&N filter for a stock airbox, fuel rails with stock injectors, and a full unused gasket set. I have a lot of the bolts, but I can't guarantee I have all of them. This would be a great conversion for a TBI or carbed car. Asking $100 + shipping OBO.
Thread
Thread Starter
Forum
Replies
Last Post