trickflow heads..the two center spring seats dont fit...???
Thread Starter
Registered User
Joined: Oct 2006
Posts: 295
From: Everywhere
trickflow heads..the two center spring seats dont fit...???
On both heads. i cant get the spring seats onto the two middle spots. its almost like they are a bit smaller..any reason for this?
Registered User
Joined: Dec 1969
Posts: 4,950
From: San Diego, CA
Is the interference with the center head bolt; if so it's not uncommon. You can grind down a small portion of the seat to get them to clear the head bolt.
Last edited by OBE1 95Z28; Mar 28, 2007 at 08:14 PM.
Thread Starter
Registered User
Joined: Oct 2006
Posts: 295
From: Everywhere
no..the ACTUAL machined area is smaller in size..however that is interfering too. When I put the spring in any of the other ones without the seat in it theres noticably more room. And its the same on both heads.
Registered User
Joined: Sep 2006
Posts: 271
From: TN
this might help. check out the specs on the spring pockets. it says somthing about i.d. spring locators for the center 2. i bought mine assembled.
http://www.trickflow.com/product/che..._lt1_specs.asp
http://www.trickflow.com/product/che..._lt1_specs.asp
Last edited by nick3; Mar 28, 2007 at 09:36 PM.
Thread Starter
Registered User
Joined: Oct 2006
Posts: 295
From: Everywhere
this might help. check out the specs on the spring pockets. it says somthing about i.d. spring locators for the center 2. i bought mine assembled.
http://www.trickflow.com/product/che..._lt1_specs.asp
http://www.trickflow.com/product/che..._lt1_specs.asp
Thread
Thread Starter
Forum
Replies
Last Post