fuel injector clips

Reply Subscribe

Thread Tools

Search this Thread

Jun 13, 2003 | 07:40 PM

MLTA96

Thread Starter

Registered User

Joined: Apr 2003

Posts: 29

fuel injector clips

I just bought the bosch #30 fuel injectors and I can't get the clips to go on. the ring on the injector isn't all the way around. do i have to use clips?

Jun 13, 2003 | 07:50 PM

drewstealth

Registered User

Joined: Mar 2003

Posts: 1,623

From: Fairfield, ca

I would. You don't want those things to move around. After some time they can wiggle loose and you could get fuel all over.

Jun 13, 2003 | 08:13 PM

madwolf

Registered User

Joined: Jul 2001

Posts: 4,577

From: DeKalb, IL

You don't have to, but it's good for safety. You can use a dremel to make a full ring on the injectors. That's what I did on a set of LS1s...

Jun 13, 2003 | 09:24 PM

MLTA96

Thread Starter

Registered User

Joined: Apr 2003

Posts: 29

thanks madwolf, i used the dremel and have just 2 left to install and finished. save the two for the morning. too dark out.

Jun 14, 2003 | 01:40 PM

MLTA96

Thread Starter

Registered User

Joined: Apr 2003

Posts: 29

with the fuel rail bolts tightened i see the part above the o-rings. the injectors won't push down any further because of the fuel rail. what gives?

Dec 11, 2004 | 04:14 PM

TobyZ28

Registered User

Joined: Aug 2002

Posts: 2,325

From: BC

Re: fuel injector clips

Quote:

Originally Posted by MLTA96

with the fuel rail bolts tightened i see the part above the o-rings. the injectors won't push down any further because of the fuel rail. what gives?

Same problem here - can anyone help?

Dec 11, 2004 | 04:16 PM

Loadre

Registered User

Joined: Jul 2001

Posts: 1,887

From: Kingsport, TN

Re: fuel injector clips

I assume you mean the lower part of the injector where it goes into the manifold? That's normal if you can see the top of the o-ring.

Dec 11, 2004 | 04:52 PM

TobyZ28

Registered User

Joined: Aug 2002

Posts: 2,325

From: BC

Re: fuel injector clips

I installed the stock clips in the upper groove of the injector, this kept the top of the injector from going too far into the fuel rail, and the o rings are now just a tad deeper and no longer visible...