Need heads to replace cracked/warped ones.

I would like them to be in good shape and not be ground on already. Let my know what's out there!

Ben T.

 

I have a completely rebuild set. They have been decked for a half-point of compression though. 80K miles on them before the rebuild. $255 + shipping

 

Brutus,

I am be getting in touch with you soon. Where are you at? Not Maine or something I hope.

I'll be looking for a pair soon. I'm getting a car in two weeks, and if the heads are really messed up they're getting replaced instead of spending money on the warped ones.

I'll let you know. I'm glad I have a pair located! If someone comes along with the money b/f me feel free to sell, but I'm glad I know where a set is.

Ben T.

 

I'm in FL. These heads have been around for a while. I was originally going to use them to replace my ported heads at a point where I thought I had a buyer for them. I paid $200 but felt they needed a rebuild. The seats were pretty worn so I did a pretty major overhaul on every aspect of the heads. The valve springs are stock valve springs, but since I replace a lot of stock valve springs I used a matched set with "as new" seat and open pressure. The total for machining came up to $155, so I'm @ a loss if you consider my cost of $355 on these heads, but I'm most likely keeping the ported ones and they need to go. Where are you located and I can give you a rough est. on shipping. Give me your zip too.

 

70769,

again, I just want a rough estimate. I'm not agreeing to buy them at this point.

Ben T.