Im looking for an L98 short block or any 350 shortblock (rebuilt preferred)

 

I've got a 82 corvette long block, under 20,000 miles, NO RIDGE A1 shape 500 plus shipping

 

I have a standard bore 350 with LT1 pistons and rods, has a custom ground roller cam (242/250@.050 - .540 lift 108 lobe seperation) cam has the cast iron distributor drive gear so you dont have to run a bronze distributor gear. 0 miles since rebuild. Shortblock for 600.00, can be had with vortech heads which have had screw in rocker arm studs installed, matching valve springs for the cam (spring pockets had to be enlarged) and mild porting for 1000.00. Might be more than what you're looking for, but I sold the car that I was building it for and don't really need it now, I put every spare dollar into my money pit LT1 now.

 

Efromm email me, that sounds good for what im planning to do. Endless448@hotmail.com ...thanks

Just give me some more info on the motor and an est on shipping

 

Breakmyfoot ...is that 600 with shipping or w/o? Email me also.. endless448@hotmail.com

 

E-mail sent. By the way, it's a late model block (1995 I believe) one peice rear seal. I really wanted to sell as a complete engine but I guess I probably wouldn't have too much trouble selling the Vortec heads seperately. If you dont want a cam that big I would probably let the block and rotating assembly go for 300.00 plus shipping, that custom ground roller cam and lifters is where I spent the largest amount of money on the shortblock.

 

yea b/c i got a cam that id like to use, so yea id like just the roatating assembly.. Alright let me figure out the shipping and well work from there? Ill send u and message or email you from now on...its easier