I'm looking for a 350. Long block/short block/complete. Whatever you've got. It must be a 1987+ (for 1-piece RMS and hydraulic cam).

Email: mxfreek125@hotmail.com

-Rippin

NOTE: No LT1/LS1's

 

Up top

 

\


LT1!!! heheeeh guess not

 

hey ...

how about this ????


Complete engine ..$2500..long block ,heads and short block itemized below


Motor ....short block $1395 , built with parts listed below .. itemized..not sold separately
$150 1991 L98 Roller 350 core
$350 machine work , hot tanked , bored .030 , magnafluxed and checked for clearances , cam bearings installed , crank turned , etc
$150 Forged Nodular LT-1/ZZ4 Crank , .010/.010
$100 LT-1/Vortec powdered metal rods , magnafluxed and checked for clearances
$225 Speed-Pro/TRW forged flat top pistons
$80 rings , Sealed power , Moly Plasma
$90 bearings , TRW/Federal Mogul Racing Series
$150 gasket kit Fel Pro
$50 ARP rod bolts
$50 LT-1 roller lifters , web and retainers


Heads $900
$300 Vortec Cores ..Casting # 906 , built with parts listed below .. itemized..not sold separately
$300 machine work , cut for bigger valves , pocket porting , viton seals , tap for studs , mill deck .030
$65 2.02 and 1.6 stainless under cut valves
$50 .600 lift springs
$30 chrome moly retainers
$20 offset keepers
$35 Viton seals
$35 ARP studs
$40 Hardened push rods
$20 Chrome moly guide plates
$150 Crane GOLD Roller Rockers , 1.6 ratio
$25 factory 1 pc rear main oi pan
$20 factory center bolt valve covers