wanted: stock rod(s), pistons, crank..
Anyone have any lt-1 parts such as rod(s),pistons or forged pistons, crank,oil pan ...
Let my roomate borrow the car for a week and the DumbA$$ ran out of oil and blew a rod... any help would greatly be appreciated..
Let my roomate borrow the car for a week and the DumbA$$ ran out of oil and blew a rod... any help would greatly be appreciated..
Hi. I have the following from my stock short block. All parts had 26,400 miles when removed from my 96 Trans Am LT1 and were in good condition.
stock crank
stock cam
another stock cam(from a 95 camaro, 63,000miles)
stock lifters
stock rods and pistons still attached
stock pushrods, rocker arms/nuts/washers all matched(ie. all pushrods/rocker arms/lifters are still mated up with the ones they were in the engine with)
stock timing chain set
water pump drive
stock springs**SOLD**
stock valves**SOLD**
Let me know what you need. Make me a decent offer an its yours. I was gonna put this all on ebay tomorrow...but Ill hold off till I hear from you since your a board member. Email me at N2OpwrdLT1@aol.com
stock crank
stock cam
another stock cam(from a 95 camaro, 63,000miles)
stock lifters
stock rods and pistons still attached
stock pushrods, rocker arms/nuts/washers all matched(ie. all pushrods/rocker arms/lifters are still mated up with the ones they were in the engine with)
stock timing chain set
water pump drive
stock springs**SOLD**
stock valves**SOLD**
Let me know what you need. Make me a decent offer an its yours. I was gonna put this all on ebay tomorrow...but Ill hold off till I hear from you since your a board member. Email me at N2OpwrdLT1@aol.com
Last edited by N2OpwrdTA; Jan 2, 2004 at 11:31 PM.
I have the rotating assembaly from a 94 LT1 and the oil pan. I was just going out to pull it apart today. The parts have 70K on them. There were no problems with it I'm just building a 383 and won't need this stuff. E-mail an offer if you would like it. Thanks.
I've got stock rods and pistons with only 10,000 miles on them. make me an offer. sardayton@yahoo.com
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
Oct 31, 2016 11:09 AM



