Torque Arm Mount For TH350???
Thread Starter
Registered User
Joined: May 2002
Posts: 332
From: Amarillo, TX
Torque Arm Mount For TH350???
Registered User
Joined: Jun 2002
Posts: 463
From: P'COLA, FL
you can use the stock x member with the B&M. it comes with a huge 3/8" thick plate to move the tranny mount back to the stock location. the hurst does not come with this piece. less fabrication is required with the B&M.
the hurst includes a bracket for the throttle and some vacuum line, but its not worth the sacrifice, IMO i run a manual valve body, so those items were useless to me.
let me know if i can help.....
the hurst includes a bracket for the throttle and some vacuum line, but its not worth the sacrifice, IMO i run a manual valve body, so those items were useless to me.
let me know if i can help.....
Thread Starter
Registered User
Joined: May 2002
Posts: 332
From: Amarillo, TX
Thanks for the help!!! I'll also be using a manual valve body so I wont need the vacuum line or the throttle piece! And the B&M stuff is cheaper
Did you use a short or long tail shaft TH350?
Thanks,
Adam
Did you use a short or long tail shaft TH350? Thanks,
Adam
Registered User
Joined: Jun 2002
Posts: 463
From: P'COLA, FL
dont know if it matters, but i used a short tail without a problem. you will need a longer driveshaft.
i run a 10" PTC converter. im all motor right now, but will be spraying it by the end of the year.
7.50 1/8 mile at 90mph motor. bout an 11.4 in the 1/4. 3600# raceweight.
i run a 10" PTC converter. im all motor right now, but will be spraying it by the end of the year.
7.50 1/8 mile at 90mph motor. bout an 11.4 in the 1/4. 3600# raceweight.
Thread
Thread Starter
Forum
Replies
Last Post