Installing a 1995 LT1 drive line into a streetrod..the stock Z28 driveshaft is 41-5/8" center to center of caps. The center of rear cap to the end of the 27 spline slip yoke is approx 47"

Could use one about 1.5" longer..just tossing this out in case someone has a longer drive shaft...before I have one made.

 

I have an aluminum drive shaft out of my V-6, that I bought from inland empire driveline. Cost me about $400. I bought it to replace the two piece V-6 drive shaft. I was told the V-6's were a little longer than the V-8. I would ask $100 plus shipping. I am parting out the car at the moment.

Let me know if your interested and I will measure it from u-joint to u-joint (you would like have to use your part that goes into the tranny as the V-6 is different).

Erik

 

Give me the center to center measurement....also let me know if it has 1-1/8" caps with inside lock rings.

thanks

 

just measured it and it came in short at 40.5 inches. Strange I thought the V-8's had shorter drive shafts than the V-6's

 

Are you still in need of a driveshaft if so i might have one for you...

 

10-4..send me an email with info.

thanks

 

?????????????? Where art thou

 

im in the southwest corner of minnesota.. i have a one piece aluminumshaft that 41 and a 47 havent made it to check the other though...

 

Disregard...had one made....