94 v6 performance chip!!
IMO, a chip will not do much you are better off doing a motor swap or getting a new car. you are not going to make a race car out of a a 3.4 it was a really dog of a motor they really dont have much potential. You really wont notice much by tuning the ECU since your car is stock might be good for a few horsepower. once you start messing with turbos, cams, etc and you have to mess with timing and your ffuel system you will start to notice. but just putting bolt on parts, cam, exhaust, intake, etc the 3.4 will only be good for MAYBE 200 hp to go above that you will be looking for forced induction, nitrous, etc spending a lot of cash and risk messing up the motor unless you plan on strengthing the internals. sorry for the long post btw.
i agree with the above post... i have had 2 3.4 camaros the first had full bolts no cam though and ran 16.5... my camaro now is bone stock with 300xxx miles and it runs 17.1... if your going to keep the car just make it look nice cause your not going to make good power... or you can do what i did and go find a wrecked 97 camaro ss and do an entire drive train swap my motor is going in next weekend muah hahaha
Thread
Thread Starter
Forum
Replies
Last Post
PFYC
Supporting Vendor Group Purchases and Sales
0
May 15, 2015 10:43 AM
chevroletfreak
LT1 Based Engine Tech
202
Jul 4, 2005 05:00 PM



