Im looking for an LT1 6-speed, this is what i need:
Transmission, bellhousing, shifter, pedals, clutch linkage, clutch itself(if it has low miles). i do not need the flywheel as for this is going in an older engine and i need a special flywheel. if anyone has anything let me know.

 

I have a 6 spd from a '99 SS with 28k miles on it. I have the stock clutch as well, but I don't know the condition other that what I can see because it was not my car. It was my buddy's. I am selling the tranny, bellhousing, clutch, shifter, skip shift eliminator for $1500.

Let me know if you're interested and if you would like to see pics.

Thanks,

Eric

 

hey, i am mainly looking for the LT1 style 6-speeds, plus i dont need a flywheel because i have to buy a $300+ and a $300+ speedometer box (X-box) so right there im already spending 600 plus for that, then the other parts, so im looking for a pretty good deal.

 

I will have a 6 speed t-56 that came out of my 96 formula that is getting rebuilt with new syncros and shift pads. This tranny is going to be totally fresh.I will be picking it up from the tranny rebuilder next week. It will come with stock shifter,bell housing and tranny.$800 plus shipping.

 

if its getting all that work done on it why are you getting rid of it? or are you putting something else in? sounds like a decent deal to me

 

This was my original tranny that came out of my 96 Formula. I had a spare that was put back into it before my buddy bought my Formula. I have no use for it because it's not good for a spare for my 99 T/A.

 

I have the whole conversion you would need. It is currently in my truck
80,000 mile lt1 6 speed
spec stage 3 clutch less than 200 miles on it
Power master starter for the 153 tooth flywheel
Conversion flywheel from centerforce for early sbc
2k for it all and you can come and drive the truck.
I only and thinking about selling for my ls1 swap.
You can email me at Elecarndt@aol.com

 

I also have the pedals and crossmembers available.

 

what did you do for the speedo in the truck?

 

have not done a speedo yet I was just going to use a aftermarket gauge for a vss setup.

 

I've got a brand new clutch master cylinder with pressure line.

 

oh i c, i cant afford 2k right now, but i can afford the other tranny for 800. im trying to stretch the cost of this over a small period, not right at one shot, if it was cheaper then id think about it more. janny-if you still have the items i might have to get them from you shortly.

 

Cool no big deal I am firm here as it cost more than that for everything by the time I was done. Thanks
Elec

 

no problem, i didnt want to waiste your time too much, on the other hand GONE-do you still have that tranny or have it back ect?

 

.