Wanting a crank for a 383 built lt1...let me know what you have! Thanks!

 

383 cola 4340 forged steel nontwist crank and new set of srp 30 over flat top pistons for 5.850 rod. 600$ for both. charlotte nc

 

not bad at all...I should have been a tad more specific..I'll need it for a 6 inch rod application...but gosh you make me want to change my mind..I don't think the crank will work...can you send me the part # and I'll have a look? thanks!

 

cols3750 it is a 3.750 stroke 1 peace seal and is ballanced for 1850 bw.it will work in a lt1 or lt4 , pistons are 146998. i can take it to a.i, cylinder heads in concord nc and you can call them and get a opinion from phill if you wont but if there is a bill for looking at it you pay it.

 

I have an eagle 4340 lightened crank made for 5.7 rods, mine is the lightened version of this one http://store.summitracing.com/partde...0&autoview=sku its been balanced I can get you the bob weight that its at now if you want the part # for mine is ESP-4353375057LA its in a short block right now never ran tho, I decided Im going to order a custom crank with a big block front snout so I dont snap a snout off with my blower. send me a PM if interested.

 

I have a 3.875" forged Eagle for 6" rods if you might consider doing a 396.
It needs to be turned (spun #4 main). My local machine shop gave me an estimate of $300 for turning and re nitriding. For that investment it should be better than new.
$50 + shipping.
I also have a slightly used set of Diamond pistons(8) and (2) new for that set-up. $100 shipped.